Categories: Troubleshooting

Bodum bistro coffee maker troubleshooting

How to start coffee maker repair on your own? First, you need to identify the problem. You will find help in the table describing the main causes of breakdowns and methods of repair without additional assistance.

FAULT	POSSIBLE CAUSE	SOLUTION
No water flow	1. Not connected to power supply	1. Unplug the machine and then plug it back in again, check switch is on
	2. Power socket failure	2. Check the socket and fuse
	3. Water inlet tap closed	3. Check that the water inlet tap is open. Check your water supply and pressure
	4. Water supply blockage or low water pressure
No hot water	1. Hot tank is not turned on	1. Turn on the hot tank switch at the back
	2. Excessive hot water use	2. Test again after 5 minutes
	3. The machine was in power saving mode	3. Wait for the hot tank to reach maximum temperature
No cold water	1. Excessive cold water use	1. Test again after 25 minutes
No cold water	2. If unused for an extended period, ice can build up in the, cold water tank	2. Turn off the power and wait 2 hours before turning it back on
Bodum bistro leaking	1. Drip tray is full and overflowing	1. Empty the drip tray and dry thoroughly before replacing
Bodum bistro leaking	2. Leak inside the Bodum bistro	2. Turn off the power and water, please contact Bodum bistroTechnical Support
Odour from the water	1. New machine	1. Drain 2L of water from each tank
	2. The machine has not been used for a long period	2. Replace the MAXI filter cartridge
	3. The filter has not been replaced when necessary	3. Replace the MAXI filter cartridge